Gaining access to the internal parts of the JD-800 is a simple process but requires a little care.
Removing all screws may do your internal components fall.You must remove only the screws AROUND the bottom and two screws in the center line, they are at 1/4 from side, and may be you can see a few bigger hole where thy fit to.
Sometimes the bottom have some "dust" acting like glue to.
 |
| Photo: Gwydion Elderwyn |
 |
| How to remove the panel. JD-800 Manual. (click to enlarge) Source: Roland Co. |
Ok? Good luck!
.'.
Hi. These instructions are incomplete. You forgot to tell people to remove the screws along the hinge aswell. Struggled for quite a while before realizing what was going on
ResponderExcluirThanks Robin for noticing this. I'll check again, I believe they are all shown in the photo in the article.
Excluir